Mark Burrows and myself were on site today. A slight mix-up over keys to the container resulted in a delay getting started and curtailed the working day somewhat. Mark scraped off the worst of the crap from both the 037 cab and no. 2 cab of 30, then painted grey undercoat on the cab front of 037 to 'smarten it up a bit'. The paintwork on all of our assets is looking faded and dirty after several years of no attention. I pulled out the cables from under the floor in front of the aux gen that go to the load limiting potentiometer to bell them out. I identified and marked all but one, which will require further investigation. I did the same for several smaller severed cables from the cubicle to the main gen. This took all day as I was doing it on my own, so I had to make repeated trips into the Thin Man's passage to move the belling lead. Although the work I've described here doesn't sound like much, it did take up a whole day but was very satisfying as it pinned down more of the cabling inside 50030.
 |
![b2ap3_thumbnail_005.JPG](/images/easyblog_shared/AMR 17-05-2014/005.JPG "A wider view of the same process. The red wire is the test "belling" wire and the white box on the right of the picture is the case for the belling buzzer.") |
